# TAG: speed # # Specifies the speed for the PPP daemon to talk at. # #speed 115200
# TAG: option # # Specifies the location of the PPP options file. # By default PPP looks in ''''/etc/ppp/options'''' # option /etc/ppp/options.pptpd
# TAG: stimeout # # Specifies timeout (in seconds) on starting ctrl connection # # stimeout 10
# TAG: debug # # Turns on (more) debugging to syslog # debug
# TAG: bcrelay <if> # # Turns on broadcast relay to clients from interface <if> # #bcrelay eth0 listen 11.1.1.97
# TAG: localip # TAG: remoteip # # Specifies the local and remote IP address ranges. # # You can specify single IP addresses seperated by commas or you can # specify ranges, or both. For example: # # 192.168.0.234,192.168.0.245-249,192.168.0.254 # # IMPORTANT RESTRICTIONS: # # 1. No spaces are permitted between commas or within addresses. # # 2. If you give more IP addresses than MAX_CONNECTIONS, it will # start at the beginning of the list and go until it gets # MAX_CONNECTIONS IPs. Others will be ignored. # # 3. No shortcuts in ranges! ie. 234-8 does not mean 234 to 238, # you must type 234-238 if you mean this. # # 4. If you give a single localIP, that''''s ok - all local IPs will # be set to the given one. You MUST still give at least one remote # IP for each simultaneous client. # localip 192.168.10.1 remoteip 192.168.10.100-240 netmast 255.255.255.0 # or #localip 192.168.0.234-238,192.168.0.245 #remoteip 192.168.1.234-238,192.168.1.245
## change ''''pptpd'''' to whatever you specify as your server name in chap-secrets name pptpd mtu 1450 mru 1450 proxyarp auth #bsdcomp 0
# This option applies if you use ppp with chapms-strip-domain patch #chapms-strip-domain nobsdcomp # These options apply if you use ppp with mppe patch # NB! You should also apply the ChapMS-V2 patch #+chap #-chapms #+chapms-v2 ipcp-accept-local ipcp-accept-remote lcp-echo-failure 3 lcp-echo-interval 5 #mppe-128 #mppe-stateless refuse-pap refuse-chap refuse-mschap refuse-eap require-mschap-v2 # These options will tell ppp to pass on these to your clients # To use ms-wins or ms-dns in options.pptpd it must exist in /etc/resolv.conf multilink require-mppe #ms-wins your.server.here #ms-dns 61.134.1.9
/etc/ppp/chap-secrets # Secrets for authentication using CHAP # client server secret IP addresses ####### redhat-config-network will overwrite this part!!! (begin) ########## ####### redhat-config-network will overwrite this part!!! (end) ############ user1 pptpd password1 * user2 pptpd password2 *
注：本站部分文章源于互联网，版权归原作者所有！如有侵权，请原作者与本站联系，本站将立即删除！ 本站文章除特别注明外均可转载，但需注明出处！ [MinTao学以致用网] 
