|
me or anybody else very much: it will depend on your particular kernel setup. What you should do is take the hex value from the EIP line (ignore the "0010:"), and look it up in the kernel namelist to see which kernel function contains the offending address. To find out the kernel function name, you''''ll need to find the system binary associated with the kernel that exhibited the symptom. This is the file ''''linux/vmlinux''''. To extract the namelist and match it against the EIP from the kernel crash, do: nm vmlinux | sort | less This will give you a list of kernel addresses sorted in ascending order, from which it is simple to find the function that contains the offending address. Note that the address given by the kernel debugging messages will not necessarily match exactly with the function addresses (in fact, that is very unlikely), so you can''''t just ''''grep'''' the list: the list will, however, give you the starting point of each kernel function, so by looking for the function that has a starting address lower than the one you are searching for but is followed by a function with a higher address you will find the one you want. In fact, it may be a good idea to include a bit of "context" in your problem report, giving a few lines around the interesting one. If you for some reason cannot do the above (you have a pre-compiled kernel image or similar), telling me as much about your setup as possible will help. - alternately, you can use gdb on a running kernel. (read-only; i.e. you cannot change values or set break points.) To do this, first compile the kernel with -g; edit arch/i386/Makefile appropriately, then do a "make clean". You''''ll also need to enable CONFIG_PROC_FS (via "make config"). After you''''ve rebooted with the new kernel, do "gdb vmlinux /proc/kcore". You can now use all the usual gdb commands. The command to look up the point where your system crashed is "l *0xXXXXXXXX". (Replace the XXXes with the EIP value.) gdb''''ing a non-running kernel currently fails because gdb (wrongly) disregards the starting offset for which the kernel is compiled.
上一页 [1] [2] [3] [4] [5] [6]
[C语言系列]C# 和 Linux 时间戳转换 [Web开发]PHP flock文件锁介绍
[Web开发]flock() Linux下的文件锁 [电脑应用]Linux下的六个免费的虚拟主机管理系统介绍
[电脑应用]Linux数据库大比拚 [操作系统]在Windows中玩转Linux操作系统
[办公软件]在RedHat Linux 9里安装gaim0.80 [办公软件]掌握 Linux 调试技术
[办公软件]理解 Linux 配置文件 [聊天工具]Real10 & Xpdf installation on Linux Box
| 
注：本站部分文章源于互联网，版权归原作者所有！如有侵权，请原作者与本站联系，本站将立即删除！ 本站文章除特别注明外均可转载，但需注明出处！ [MinTao学以致用网] 
